Leadership Quote by Captain Hank Bracker, "Seawater One

““As cadets, we constantly hammered, scraped and wire brushed rusting steel, before applying red lead paint. Most of the paint we used was Navy surplus or a concoction made up of fish oil, lampblack and china dryer. We found that by mixing all different color paints, we would wind up with a paint we called “Sh-t Grindle Brown.” Inventiveness was key as we repaired, replaced, and painted the State of Maine from stem to stern. This work, being in addition to our studies, consumed all of our time. How we managed to fit all of this into the time we had, is still a mystery. The conversion of the ship was labor intensive and expensive, but the U.S. Maritime Commission contributed to the Academy’s financial needs where possible. The mounting expenses remained a challenge but we didn’t give up. We never did finish the entire conversion prior to our first cruise, but one thing we managed to do was paint over the name “USS Comfort” and hand letter in her new name “State of Maine.” If you looked carefully, you could still see her previous name outlined by a welded bead, but this was a minor detail that would eventually be taken care of. Perhaps because of my experience with the letters on the front of “Richardson Hall,” the task of lettering her name and her new homeport on the stern became mine. Much of the ship’s superstructure was still covered with a sticky preservative made up of paint and crank case oil, which never really dried and indelibly got onto our working uniforms. However, from a distance, you couldn’t tell the difference and it looked all right, but more importantly it prevented further rusting. One bulkhead at a time, using a mixture of gasoline and paint remover, we scraped the gunk off and repainted it. The engineers had been busy rebuilding the pumps and generators, as well as repacking steam pipes with asbestos wrapping. We finally got the ship to where we could sail her to Portland under her own power. The twin Babcock and Wilcox heater-type boilers had to be repaired and re-bricked there. After this, we would continue on to the dry dock in Boston for additional work and the hull inspection that was required below the water line.””

— Captain Hank Bracker, "Seawater One