“Step 2: Build the LED-Controlling Circuit Now, you’re going to connect the 4017 decade counter with resistors and LEDs. There are a… — Oyvind Nydal Dahl Copy Share Image
“Check the Continuity First, check that you don’t have a short circuit between the positive and negative columns. To do this, use the continuity… — Oyvind Nydal Dahl Copy Share Image
“Step 4: Practice Your Reaction Time! All that’s left is to connect the battery to the supply columns. The button at the bottom of… — Oyvind Nydal Dahl Copy Share Image
“NOTE Many electronics enthusiasts also call continuity mode beep mode.” — Oyvind Nydal Dahl Copy Share Image
“MEET THE REACTION GAME CIRCUITS The reaction game will consist of three circuits: A 555 timer circuit that determines the speed of the game… — Oyvind Nydal Dahl Copy Share Image
“ADD A BUZZER TO YOUR GAME Congratulations: You’ve finished the last project in the book! Now, it’s up to you to decide what to… — Oyvind Nydal Dahl Copy Share Image
“Before you move on to the next step, check that this circuit is working by connecting an LED with a resistor to the output… — Oyvind Nydal Dahl Copy Share Image
“Check for Bad and Good Beeps Now, plug your battery clip into the breadboard as you would normally, but without the battery. Touch one… — Oyvind Nydal Dahl Copy Share Image
“Step 4: Use the Capacitor to Light the LED Watch the LED while removing the battery. The LED shouldn’t turn off right away when… — Oyvind Nydal Dahl Copy Share Image
“Shopping List A breadboard (Jameco #2212218, Bitsbox #CN204) with at least 60 rows. Breadboard jumper wires (Jameco #2237044, Bitsbox #CN236)—you’ll need around 35 for… — Oyvind Nydal Dahl Copy Share Image
“Check for Power If the connection to the NAND-gate IC is correct, use a multimeter to measure the output voltage from the start/stop circuit… — Oyvind Nydal Dahl Copy Share Image
“A Counter to Turn the LEDs On To control the LEDs, you’ll use a decade counter, which is an IC that counts input pulses.… — Oyvind Nydal Dahl Copy Share Image
“Step 5: What If the Game Isn’t Working? If you’ve followed my instructions so far, the circuits from Steps 1 and 2 should be… — Oyvind Nydal Dahl Copy Share Image
